Expedition 2WD V8-5.4L SOHC VIN L (1997)
4. Select the proper pinion adjustment shim. See: Specifications/Mechanical Specifications
CAUTION: When selecting the pinion adjustment shim the correct shim must be installed or damage may occur.
5. Use a press and Inner Pinion Bearing Cone Replacer to press the differential pinion bearing until it is firmly seated on the pinion and pinion
adjustment shim.
NOTE: The same pinion bearing used in this procedure must be used in the final axle assembly.
6. Place a new collapsible spacer on the pinion shaft.
7. Lubricate the lip of the pinion seal and the splines on the pinion shaft with Motorcraft Synthetic Rear Axle Lubricant F1TZ-19580-B or equivalent
meeting Ford specification WSL-M2C192-A.
8. Install the pinion seal.
(1) Install the outer differential pinion bearing.
(2) Install the oil slinger in the axle housing.
(3) Install the (A) pinion seal with (B) Pinion Seal Replacer.
CAUTION: Installation without the proper tool may result in early seal failure. If the pinion seal becomes cocked during installation, remove it
and install a new one.
