Expedition 2WD V8-5.4L SOHC VIN L (1997)
4. Install a new centering cup spring.
5. Install new bearing cups into the driveshaft yokes.
(1) Start a new bearing cup into the driveshaft yoke.
(2) Position the new spider in the driveshaft yoke.
(3) Position the driveshaft in U-Joint Tool.
(4) Press the bearing cup below the yoke surface.
-
Repeat for the other yokes.
6. Install four new snap rings.
7. Check the U-joints for freedom of movement.
-
If bearings are binding, strike the yoke with a plastic hammer.
NOTE: Do not strike the bearings.
8. Install driveshaft.
Single Cardan
DISASSEMBLY
1. Remove driveshaft.
2. Place the driveshaft on a suitable workbench, being careful not to damage the tube.
CAUTION: Do not clamp the driveshaft in the jaws of a vise or similar holding fixture.
