ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Gravity Bleeding|Page 6438 > < Gravity Bleeding|Page 6436
Page 1
background image

Brake Bleeding: Service and Repair
Pressure Bleeding

WARNING:  BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING WATER FOR 15
MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY, DRINK WATER AND INDUCE
VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
 

CAUTION:

-

Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled with
the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.

-

Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

NOTE:

-

When any part of the hydraulic system has been disconnected for repair or replacement, air may get into the system and cause spongy brake
pedal action. This requires bleeding of the hydraulic system after it has been properly connected. The hydraulic system can be bled manually
or with pressure bleeding equipment.

-

Bleed the longest line first. Be sure the bleeder tank contains enough specified brake fluid to complete the bleeding operation.

1. Clean all dirt from and remove the brake master cylinder filler cap and fill the brake master cylinder reservoir with the specified brake fluid.
2. Install the bleeder adapter to the brake master cylinder reservoir and attach the bleeder tank hose to the fitting on the adapter.

NOTE:  Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment. Follow the
instructions of the manufacturer when installing the adapter.

3. Place a box end wrench on the RH rear disc brake caliper bleeder screw. Attach a rubber drain tube to the RH rear disc brake caliper bleeder screw

and submerge the free end of the tube in a container partially filled with clean brake fluid.

4. Open the valve on the bleeder tank.

Gravity Bleeding|Page 6438 > < Gravity Bleeding|Page 6436