Expedition 4WD V8-281 4.6L SOHC (1998)
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
NOTE: Remove all dirt from the mounting surface and sensor to prevent contamination of rear axle lubrication.
INSTALLATION
1. Clean and inspect the rear anti-lock brake sensor.
1
Clean the axle mounting surface.
2
Inspect and clean the magnetized rear anti-lock brake sensor pole piece.
3
Inspect the rear anti-lock brake sensor O-ring for damage. Replace if necessary.
4
Lightly lubricate the rear anti-lock brake sensor O-ring with Synthetic SAE 75W-140 Rear Axle Lubricant F1TZ-19580-B or equivalent
meeting Ford specification WSL-M2C192-A.
CAUTION: Use care not to get dirt in the rear axle housing.
2. Install the rear anti-lock brake sensor.
1
Position the rear anti-lock brake sensor and install the rear anti-lock brake sensor bolt.
NOTE: Do not apply force to the plastic rear anti-lock brake sensor connector.
2
Connect the electrical connector.