Expedition 4WD V8-281 4.6L SOHC (1998)
4. Remove the EGR valve to exhaust manifold tube.
^
Disconnect the upper and lower EGR valve to exhaust manifold tube fittings.
^
Disconnect the two DPFE hoses.
5. Remove the LH valve cover.
^
Fully loosen the bolts and remove the valve cover.
^
Inspect the valve cover gasket and clean the mating surface of the cylinder head.
INSTALLATION
NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with Metal Surface Cleaner F4AZ-19A536-A or
equivalent meeting Ford specification WSE-M5B392-A. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to
follow this procedure can cause future oil leakage.
1. Apply a bead of silicone in two places where the engine front cover meets the cylinder head.
^
Use Silicone Gasket and Sealer F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6.
