Expedition 4WD V8-281 4.6L SOHC (1998)
7. Spread the retainer tabs apart and slide the retainer off the tube.
8. Discard the retainer.
CONNECT
1. Clean the tubes and lubricate with Ford Rubber Suspension Insulator Lube E25Y-19553-A or equivalent meeting Ford specification
ESR-M99B112-A.
2. Install a new coupling retainer, spacer, and lubricated O-rings into the quick disconnect coupling housing.
3. Push the heater water hose with a quick disconnect coupling onto the tube.
4. Make sure the coupling is fully engaged by lightly pulling on the heater water hose.
