Expedition 4WD V8-281 4.6L SOHC (1998)
INJURY.
NOTE: The passenger side air bag module is shown; the driver side air bag module is similar.
1. Remove the passenger side air bag module.
2. Cut the two connector wires on the passenger side air bag module, and strip 25 mm (1 inch) of insulation from the ends of the wires.
3. Obtain two wires at least 6.1 meters (20 feet) long and connect one end of each wire to each of the wires on the passenger side air bag module.
4. Place the passenger side air bag module on a flat surface with the deployment door facing upward in an open outdoor area.
5. Remain at least 6.1 meters (20 feet) away from the passenger side air bag module.
6. Deploy the air bag by touching the other ends of the two wires to the terminals of a 12-volt battery.
7. Allow at least ten minutes before approaching the deployed air bag to allow for cooling.
8. Dispose of the deployed air bag module in the same manner as any other part to be scrapped.
