Expedition 4WD V8-281 4.6L SOHC (1998)
2. Remove the instrument panel relay cover.
3. Remove the passenger side air bag module.
1. Remove the screws.
2. Disconnect the electrical connector.
3. Remove the passenger side air bag module.
4. If the passenger side air bag module is diagnosed as faulty, dispose of the air bag.
INSTALLATION
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE.
^
CARRY A LIVE AIR BAG MODULE WITH THE AIR BAG AND DEPLOYMENT DOOR POINTED AWAY FROM YOUR BODY.
AN ACCIDENTAL DEPLOYMENT WILL THEN DEPLOY WITH A MINIMAL CHANCE OF INJURY.
^
NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE. DOING SO CAN RESULT IN AIR BAG DEPLOYMENT,
WHICH CAN RESULT IN PERSONAL INJURY.
NOTE: A repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM)
relearns its adaptive strategy The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
1. Follow the removal procedure in reverse order.
