Expedition 4WD V8-281 4.6L SOHC (1998)
6. Using a soft-faced hammer, drive the pinion assembly out of the front bearing cone and remove it through the rear of the housing.
7. Use the bearing pulling attachment to remove the pinion bearing cone and roller assembly.
8. NOTE: Do not remove the pinion bearing cups from the carrier casting unless the cups are damaged.
If the pinion bearing cups are to be replaced, tap alternately (with a brass drift of suitable length) on opposite sides of the cup during removal to
prevent the cup from cocking in the casting.
INSTALLATION
1. Drive the outer pinion bearing cup into the axle housing using the Pinion Bearing Cup Replacer and Driver Handle.
