Expedition 4WD V8-281 4.6L SOHC (1998)
7. Install the Gauge Tube.
1
Position the Gauge Tube.
2
Install the differential side bearing caps.
3
Install the four differential side bearing cap bolts.
8. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the gauge
tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of integral rear
axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
9. Use a press and Pinion Bearing Cone Replacer to press the pinion bearing until it is firmly seated on the pinion and pinion shim.