Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
Remove Rear Wheel Disc Brake Shield
REMOVAL
1. Remove the rear wheel disc brake adapter.
2. Remove the rear wheel disc brake shield, by drilling out the two rivets.
INSTALLATION
To install, reverse the removal procedure. Seal the rivet holes with Silicone Rubber D6AZ-19652-AA or equivalent meeting Ford specification
ESB-M4G92-A.
NOTE: Because the rear wheel disc brake shield is held in position by the four rear wheel disc brake adapter bolts, new rivets are not required.