Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
2. Install the front brake hose; torque banjo bolt to 30-40 Nm (23-29 ft. lbs.).
^
Use new copper washers to connect the brake hose.
3. Bleed the disc brake caliper. See: Bleeding
4. Clean the wheel hub mounting surface.
WARNING: Always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the
wheel hub, brake drum or disc brake rotor that contacts the wheel. Installing wheels without proper metal to metal contact at the wheel
mounting surfaces can cause the lug nuts to loosen and come off while the vehicle is in motion, causing loss of control.
Install Wheel And Tire Assembly
5. Install the wheel and tire assembly.
a. Position the wheel and tire assembly.
b. Install the lug nuts and snug to fully seat wheel and tire assembly, lower the vehicle.
c. Tighten the lug nuts.
d. Install the center cap.
6. Inspect the brake system for normal operation.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.