Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
Parking Brake Cable: Service and Repair
Rear
Left
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the rh kick panel area. Failure to do so may result in unexpected
inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
REMOVAL
1. Relieve the tension on the parking brake system.
a. Pull the front parking brake cable and conduit.
b. Insert a suitable retainer.
NOTE: Make sure the parking brake control is fully released.
2. Raise and support the vehicle.
3. Separate the RH parking brake rear cable and conduit from the LH parking brake rear cable and conduit at the parking brake cable equalizer.
4. Compress the parking brake cable clip. Remove the LH parking brake rear cable and conduit from the parking brake cable bracket.
5. Remove the screw.
