Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
Brake Switch (Cruise Control): Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the brake pressure switch electrical connector.
3. Remove the brake pressure switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery is disconnected and reconnected, some abnormal drive systems may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
NOTE: After the procedure is finished refer to brake bleeding procedure.
