Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
78.
On 4.6L engines, proceed as follows:
^
Loosely position right side fuel charge harness on cam cover.
^
Connect water temperature sensor electrical connector.
^
Connect ECT sensor electrical connector.
^
Connect right side ignition wires to spark plugs.
^
Clip ignition wire separators to right cam cover.
^
Connect right side fuel injector electrical connectors.
^
Clip right side fuel charge harness to cam cover.
^
Install right side ignition coil. Tighten retainers to 20-30 Nm (15-22 lb-ft).
^
Connect ignition wires to right side coil.
^
Connect right side radio interference suppressor electrical connector.
^
Connect right side coil pack electrical connector.
79.
On 5.4L engines, proceed as follows:
^
Install right side ignition coils. Tighten retainers to 5-7 Nm (44-62 lb-in).
^
Position right side fuel charge harness on cam cover studs.
^
Connect right side fuel injector electrical connectors.
^
Connect right side ignition coil electrical connectors.
^
Connect right side radio interference suppressor.
80.
Install PCV valve and line assembly.
81.
Connect ground strap to bulkhead.
82.
Connect heater return hose to heater core.
83.
Install heater supply hose.
84.
Install junction block bracket. Tighten retainers securely.
85.
Connect single-pin electrical connector.
86.
Connect 16-pin electrical connector.
87.
Install both 42-pin bulkhead electrical connector halves to junction block bracket.
88.
Connect both 42-pin bulkhead electrical connectors. Tighten retainers to 4-5 Nm (35-44 lb-in).
89.
Clip two (2) mega-fuses to junction block bracket.
90.
Connect positive leads to starter relay.
91.
Install junction block bracket splash shield.
92.
Connect fuel lines to fuel manifold.
93.
On 4.6L engines, proceed as follows:
^
Connect left side ignition wires to spark plugs.
