Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
12.
Tighten left cylinder head bolts in sequence shown in Figure 50 in the following three (3) stages:
^
Stage 1: 37-43 Nm (27-32 lb-ft).
^
Stage 2: Rotate 85-95 degrees.
^
Stage 3: Rotate 85-95 degrees.
13.
Lubricate all camshaft journals.
14.
Raise vehicle.
15.
Install transmission indicator tube retainer to right cylinder head if equipped. Tighten retainer to 18-23 Nm (14-16 lb-ft).
16.
Install right side exhaust manifold gasket.
NOTE:
Due to clearance, the exhaust system Y-pipe mounting flange cannot be positioned on the exhaust manifold outlet after the exhaust manifold is
installed on the cylinder head.
