Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
^
Clip ignition wire separators to left cam cover.
^
Connect left side fuel injector electrical connectors.
^
Clip left side fuel charge harness to cam cover.
^
Install left side ignition coil. Tighten retainers to 20-30 Nm (15-22 lb-ft).
^
Connect ignition wires to left side coil.
^
Connect left side radio interference suppressor electrical connector.
^
Connect CMP electrical connector.
^
Connect left side coil pack electrical connector.
^
Connect DPFE transducer electrical connector.
^
Connect IAC motor electrical connector.
^
Connect TP sensor electrical connector.
^
Connect EVR solenoid electrical connector.
^
Connect crankcase vent tube to left cam cover.
^
Position power steering reservoir and bracket in installed position. Tighten upper retainers to 8-12 Nm (71-107 lb-in). Tighten lower retainers
to 35-45 Nm (26-33 lb-ft).
94.
On 5.4L engines, proceed as follows:
^
Install left side ignition coils. Tighten retainers to 5-7 Nm (44-62 lb-in).
^
Connect left side fuel injector electrical connectors.
^
Connect left side ignition coil electrical connectors.
^
Connect ECT sensor electrical connector.
^
Connect TP sensor electrical connector.
^
Connect EVR solenoid electrical connector.
^
Connect DPFE transducer electrical connector.
^
Connect left side radio interference suppressor electrical connector.
^
Connect IAC motor electrical connector.
^
Connect brake booster vacuum line to throttle body adapter, then install brake booster vacuum line bracket to intake manifold.
^
Connect VMV purge line to top of throttle body adapter.
^
Position vacuum harness on top of motor.
^
Connect vacuum tap to right side of throttle body adapter.
^
Connect EVR solenoid vacuum line.
^
Connect EGR valve vacuum line.
^
Connect fuel pressure regulator vacuum line.
^
Connect vapor management valve vacuum line.
