Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
To install, reverse the removal procedure.
-
Check the restraint system for proper operation.
60% Portion
REMOVAL
1. Remove the headrest. Insert pin into hole to release rod on both sides.
2. Remove the second row armrest. Remove the four bolts (two each side).
3. Remove the latch control cable from the seat back. Disconnect the cable from the seat back latch. Remove the screw.
4. Remove the flipper panel latch. Pry the latch apart.
5. Remove the flipper panel cover.
6. Remove the seat cushion support bar.
7. Remove the seat cushion from the seat back.
8. Remove the safety belt divider.
9. Remove the seat cover retainers.
10. Remove the safety belt buckle.
1
Use Safety Belt Bolt Bit to remove the bolt.
2
Remove the buckle.