Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
NOTE:
Refer to the table to cross-reference circled letters to part description.
1.
Position new rear axle on jack stands.
2.
Position differential nose on an upward angle using third jack stand. This will allow control arms to clear axle when vehicle is lowered.
3.
Lower vehicle over axle.
NOTE:
Do not tighten retaining nuts at this time.
4.
Connect the following components to the rear axle:
^
Air springs
^
Lower control arms (use bolt [A] and nut [C]).
^
Upper control arms (use bolt [A] and nut [B]).
^
Shock absorbers (use bolt [I] and nut [J]).
^
Sway bar retainers (use bolt [E] and nut [D]).
^
Track bar (use bolt [F] and nut [G]).
5.
Raise and support vehicle.
6.
Position hydraulic jack under rear axle.
7.
Raise rear axle until lower control arms are parallel to the ground.
NOTE:
Tighten both left and right sides of a component before proceeding to the next component.
8.
Tighten the following components:
