Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
Ride Height Sensor: Service and Repair
REMOVAL
1. Raise and support the vehicle.
WARNING: THE ELECTRICAL POWER TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO HOISTING,
JACKING OR TOWING AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE AIR
SUSPENSION SWITCH LOCATED IN THE RH KICK PANEL AREA. FAILURE TO DO S O MAY RESULT IN UNEXPECTED
INFLATION OR DEFLATION OF THE AIR SPRINGS WHICH MAY RESULT IN SHIFTING OF THE VEHICLE DURING THESE
OPERATIONS.
2. Remove the air suspension height sensor.
(1) Disconnect electrical connector.
(2) Depress the metal retaining tabs and remove the air suspension height sensor from the ball studs.
NOTE: The air suspension height sensor has a plastic harness retainer to suspension that must be unclipped prior to removal.
INSTALLATION
1. To install, reverse the removal procedure.