Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
15.
Check for outside weld of track bar bracket to frame rail. See Figure 5.
NOTE:
Perform the following step only if the weld in the previous step is missing. If the weld was present in the previous step, go to Step 17.
WARNING
POSITION A WELD SHIELD OVER THE FUEL, VAPOR AND BRAKE TUBES IN THE AREA TO BE WELDED. COVER THE SHIELD
WITH WET RAGS TO PROTECT IT FROM THE HEAT FROM THE WELDING PROCEDURE.
CAUTION
Do not use oxy-acetylene torch to weld brackets or frame members. Excessive heat may weaken the metal in the frame members and cause
permanent damage.
CAUTION
As a precaution against damage to electrical components, be sure to disconnect the battery cables before using any welding equipment. Also it is
imperative to connect the ground clamp as close to the work area as possible. Perform all welding using Rotunda mig wire feed welder 164-R3667 or
equivalent using a 75/25 or 80/20 Argon/CO2 gas mix, and welding wire meeting AWS-E-705 specification. It is essential that the repair welds,
particularly on load bearing parts or parts contributing to the strength of the assembly, are equivalent to the original in size, type and strength.
16.
To place weld on track bar bracket to frame rail, proceed as follows:
^
Partially lower vehicle.
^
Disconnect positive battery cable from the battery.
