Expedition 4WD V8-4.6L SOHC VIN 6 (1997)
29. Measure the differential case runout without the ring gear.
-
Check the case runout again with the new differential bearings. If the runout is now within 0.076 mm (0.003 in), use the new differential
bearings for assembly. If the runout is still excessive, the differential case is damaged and should be replaced.
NOTE: Specification shown is the maximum differential case runout allowable.
30. Remove the differential case from the axle housing.
Installation
1. Press the new (A) anti-lock speed sensor ring and the (B) ring gear on the differential case.
2. Install the ring gear bolts.
-
Apply Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-A1 to ring gear bolts.
3. If the pinion beating cups were removed, install the pinion bearing cups with Pinion Bearing Cup Replacer, ensuring the pinion bearing cups are
fully seated.
NOTE: Differential pinion bearings and cups must be replaced in sets.
