Expedition 4WD V8-4.6L SOHC VIN W (1999)
1. Follow the removal procedure in reverse order.
Rear
Removal
1. Remove the rear wheel disc brake adapter.
2. Remove the rear wheel disc brake shield.
1. Drill out the rivets.
2. Remove the rear wheel disc brake shield.
Installation
1. NOTE: Because the rear wheel disc brake shield is held in position by the four rear wheel disc brake adapter bolts, new rivets are not required.
Seal the rivet holes with Silicone Rubber D6AZ-19562-AA or equivalent meeting Ford specification ESB-M4G92-A, and install the rear wheel
disc brake shield.
2. Install the rear wheel disc brake adapter.
