Expedition 4WD V8-4.6L SOHC VIN W (1999)
5. Bleed each brake tube at the brake master cylinder as follows:
1. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
2. Loosen the rearmost brake tube fittings until a stream of brake fluid comes out. Have an assistant maintain pressure on the brake pedal while
tightening the brake tube fitting.
3. Repeat this operation until clear, bubble-free fluid comes out.
4. Refill the brake master cylinder reservoir as necessary. Repeat the bleeding operation at the front brake tube.
6. While the assistant maintains pressure on the brake pedal, tighten the brake tubes.
Disassembly and Assembly
Disassembly
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately.
1. Remove the brake master cylinder.
2. Clean the outside of the brake master cylinder.
3. Remove the brake master cylinder filler cap and drain the remaining brake fluid. Do not reuse the drained fluid.
4. On speed control equipped vehicles, remove the brake pressure switch.
