Expedition 4WD V8-4.6L SOHC VIN W (1999)
7. Tighten the three peanut fittings.
8. Install the line brackets.
1
Position the bracket.
2
Install the nut.
3
Snap the line securely into the bracket.
CAUTION
-
Verify that clearance exists between the frame and the lines to prevent component damage.
-
Overtightening of the nut will cause the stud to break away from the floorpan.
NOTE: The bracket must be positioned equally between the white location marks on the line.
9. Connect the heater water outlet line to the engine heater outlet hose coupling.
10. Install the bolts, the pin-type retainers and the front fender splash shield.
11. Install the wheel and tire assembly.
12. Lower the vehicle.
13. Turn on the air suspension switch, if equipped.
14. Fill the cooling system.
