Expedition 4WD V8-4.6L SOHC VIN W (1999)
1. To install, reverse the removal procedure.
^
Lubricate the O-ring seal with PAG Compressor Oil F7AZ-19589-DA or equivalent meeting Ford specification WSH-M1C231-B.
Front Auxiliary Evaporator Outlet and Inlet Line
REMOVAL
NOTE: The 5/8 inch front auxiliary evaporator outlet line is shown, the 3/8 inch front auxiliary evaporator inlet line is similar.
1. Recover the refrigerant from the system.
2. Turn the air suspension switch off, if equipped.
3. Raise and support the vehicle.
4. Remove the wheel and tire assembly.
5. Remove the RH front fender splash shield.
1
Remove the bolts.
2
Remove the pin-type retainers.
3
Remove the front fender splash shield.
6. Remove the three line bracket retaining nuts.
