Expedition 4WD V8-4.6L SOHC VIN W (1999)
12. Cut the 3/8 inch evaporator inlet line near the rear crossmember.
13. Cut the 3/8 inch evaporator inlet line forward of the rear wheel opening.
14. Cut the 3/8 inch evaporator inlet line between the frame and the muffler heat shield.
15. Remove and discard the cut sections.
INSTALLATION
NOTE: Lay out new lines in vehicle position to assist in installation.
1. Install the inlet line.
^
Install the end with the hose over the rear axle between the frame and the body.