Expedition 4WD V8-4.6L SOHC VIN W (1999)
Fuel Injector Wiring Harness: Service and Repair
REMOVAL
WARNING: DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR
ANY FUEL RELATED COMPONENTS. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
1. Disconnect the battery ground cable.
2. Remove the wiring splash shield.
3. Loosen tie bolt and disconnect the 42 pin engine bulkhead connector.
4. Disconnect the (A) fuel charging wiring electrical connector from the (B) engine control sensor wiring electrical connector.
NOTE: The (A) fuel charging wiring electrical connector and the (B) engine control sensor wiring electrical connector are located behind the (C)
mount.
