Expedition 4WD V8-4.6L SOHC VIN W (1999)
16.
Using the jack handle removed previously, unclip both of the front fuel lines from the front clip. See Figure 3. A 24 to 28-inch flat screwdriver will
work instead of the jack handle.
17.
Remove both of the front fuel lines from the vehicle.
18.
Transfer the safety clips used on the fuel manifold connections, to the new front fuel lines.
19.
On 4 x 4 models, remove the fuel filter from its mounting bracket and reposition it below the frame rail.
20.
Disconnect the rear fuel supply line from the fuel filter.
21.
On 4 x 4 models, install the fuel filter back into its mounting bracket.
22.
Position an adjustable jack under the fuel tank. Raise the jack to support the fuel tank.
23.
Remove the fuel tank straps. On 4 x 4 models, the skid plate and the fuel tank straps are riveted together.
24.
Disconnect the fuel filler hose from the fuel tank.
25.
Lower the fuel tank approximately 15 cm (6 in). On 4 x 4 models, lower the skid plate and fuel tank as an assembly.
