Expedition 4WD V8-4.6L SOHC VIN W (1999)
45.
Connect the front fuel return line to the rear fuel return line. Reattach the safety clip.
46.
On 4 x 4 models, install the front driveshaft as follows:
^
Aligning the marks made previously, position the front driveshaft on the front axle flange.
^
Install the driveshaft mounting flange retaining bolts. Tighten the bolts to 103 Nm (76 lb-ft).
47.
On 4 x 4 models, install the transfer case skid plate. Tighten the retaining bolts to 15 Nm (11 lb-ft).
48.
Lower the vehicle.
49.
Connect both of the fuel lines to the fuel manifold. Reattach the safety clip.
50.
Install the jack handle on the radiator support.
51.
Replace the fuel that was drained during step number 8.
52.
Connect the battery negative cable, then remove the memory saver.
53.
Turn the ignition key to the ON position to pressurize the fuel system. Check the fuel lines for leaks and repair as necessary.
54.
Turn on the air suspension switch.
