Expedition 4WD V8-4.6L SOHC VIN W (1999)
Control Module HVAC: Service and Repair
Illumination Bulbs
REMOVAL
1. Remove the Control assembly.
2. Unsnap the bezel and pivot it open.
^
To replace the general illumination bulbs, unscrew the lamp holder and remove the bulb.
^
To replace the HI/LO bulb, cut the wires close to the bulb base, splice the wires to the new bulb and wrap the splice with electrical tape.
NOTE: Place the module upside down on a non-marring surface.
INSTALLATION
1. To install, reverse the removal procedure.