Expedition 4WD V8-4.6L SOHC VIN W (1999)
5. Remove the glove compartment.
1
Remove the three screws.
2
Remove the glove compartment.
6. Disconnect the Restraint Control Module (RCM) electrical connector.
1
Disengage the RCM electrical connector locking clip.
2
Disconnect the RCM electrical connector.
7. Remove the RCM with bracket.
1
Remove the four retaining bolts.
2
Remove the RCM with bracket.
NOTE: Upper RCM bracket retaining screws are accessed through the glove compartment opening.
INSTALLATION
WARNING: The tightening torque of the air bag restraint control module retaining bolts is critical for proper system operation.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
