Expedition 4WD V8-4.6L SOHC VIN W (1999)
1. NOTE: Align the marks made during removal.
Install the front suspension upper arm.
1
Position the front suspension upper arm.
2
Install the front suspension upper arm bolts.
3
Install the front suspension upper arm nuts.
2. Install the front suspension arm upper ball joint castle nut.
1
Position the front wheel knuckle.
2
Install the upper ball joint castle nut.
3
Install a new cotter pin.
3. Position the anti-lock sensor wire.
-
Install the front brake anti-lock sensor wire bracket bolt.
4. Remove the jack.
5. WARNING: the wheel is installed, always remove any corrosion, dirt or foreign material that may be present on the mounting surfaces
of the wheels or the surfaces of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without proper
metal-to-metal contact at the wheel mounting surfaces can cause the lug nut to loosen and the wheel to come off while the vehicle is in
motion, causing loss of control.
WARNING: Retighten at 800 km (500 miles) after any wheel change or any time the lug nuts are loosened.
WARNING: Failure to retighten lug nuts at the mileage specified could allow wheels to come off while the vehicle is in motion, possibly
causing loss of vehicle control and collision.
Install the tire and wheel assembly.
