Expedition 4WD V8-4.6L SOHC VIN W (1999)
4. Install a 6.73 mm (0.26 inch) shim on the left side.
5. CAUTION: Mark the position off the bearing caps, as arrows may not be visible. The bearing caps must be installed in their identical
locations and positions.
NOTE: Apply pressure toward the left side to make sure the left bearing cup is seated.
Install the left bearing cap and loosely install the bearing cap bolts.
6. Install progressively larger shims on the right side until the largest shim selected can be assembled by hand.
7. Install the right side bearing cap and tighten the left side and right side bolts to specification.