Expedition 4WD V8-4.6L SOHC VIN W (1999)
1
Position the driveshaft center yoke in the U-Joint Tool.
2
Press out the bearing cup.
3
Rotate the driveshaft center yoke.
4
Press out the remaining bearing cup. Repeat to remove the spider from the driveshaft yoke.
Assembly
1. Install a new bearing cup into the driveshaft yoke.
1
Start a new bearing cup into the driveshaft yoke.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup below the yoke surface.
5
Repeat for the other side of the yoke.
2. Install the driveshaft center yoke.
1
Position the driveshaft center yoke in the U-Joint Tool.
2
Press in a new bearing cup.
3
Rotate the driveshaft center yoke.
4
Press in the other new bearing cup.
3. Install four new snap rings.
