Expedition 4WD V8-4.6L SOHC VIN W (1999)
7.
Bend flange inboard about 10 degrees, using a pair of sheet metal clamp locking pliers (Figure 1). Starting at the bend at the top of the sail plate,
and working down approximately 25.40 cm (10") (Figure 2).
NOTE
TAKE CARE NOT TO OVER BEND FLANGE, THIS MAY INDUCE WIND NOISE.
8.
Reposition front window run.
a.
Install retainer.
b.
Torque retainer to 11 N.m (8 lb-ft).
9.
Install inner and outer belt molding.
10.
Install exterior mirror, refer to Workshop Manual Section 501-09.
11.
Install inner door panel, refer to Workshop Manual Section 501-11.