Expedition 4WD V8-5.4L (2007)
Material
Removal
1. Remove the transmission.
2. Remove the oil pan.
3. Remove the 8 bolts and the flexplate.
4. Using the special tools, remove the crankshaft oil slinger.
^
Discard the crankshaft oil slinger.
5. Using the special tools, remove the crankshaft rear seal.
^
Discard the crankshaft rear seal.
6. Remove the 6 bolts and the crankshaft rear seal retainer plate.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: Clean the sealing surfaces with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow
