Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Body / Frame Mount Bushing: Service and Repair
Body Support - Radiator Support
BODY SUPPORT - RADIATOR SUPPORT
Removal and Installation
WARNING: If equipped with air suspension, the electrical power to the air suspension system must be shut down prior to hoisting, jacking or
towing an air suspension equipped vehicle. This can be accomplished by turning off the air suspension switch located at the left rear interior of
the vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during
these operations.
NOTE: Left side shown, right side similar.
Upper and lower body mount
1. Remove the lower radiator body mount.
1
Remove the lower radiator body mount bolt.
2
Remove the lower radiator body mount.
Upper body mount
2. Loosen the remaining body mount bolts.
3. Raise the vehicle body enough to remove the upper body mount.
Upper and lower body mount
4. NOTE:
-
No lubricants of any kind are to be used during body mount installation.
-
Do not reuse body mount fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
To install, reverse the removal procedure.
