Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Sunroof / Moonroof Frame: Service and Repair
ROOF OPENING PANEL FRAME
Removal and Installation
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including whenever the roof
opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed, or when a new roof
opening panel assembly has been installed. Refer to Roof Opening Panel Motor Initialization. See: Service and Repair/Roof Opening Panel Motor
Initialization
1. Remove the headliner.
2. Remove the overhead console bracket.
-
Remove the screws.
3. Disconnect the electrical connector and cut the tie strap.
4. Remove the roof opening panel frame.
1
Disconnect the four roof opening panel drain hoses.
2
Remove the 11 bolts.
3
Remove the roof opening panel frame.
5. To install, reverse the removal procedure. If a new roof opening panel frame is being installed, transfer the existing roof opening panel motor, air
deflector, rear trough, roof opening panel glass and roof opening panel shield onto the new frame assembly. Initialize the roof opening panel
motor. Refer to Roof Opening Panel Motor Initialization. See: Service and Repair/Roof Opening Panel Motor Initialization
