Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Power Seat Motor: Service and Repair
Front Seat Track Motor
FRONT SEAT TRACK MOTOR
Removal
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental
restraint system (SRS) must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All motors
1. Remove the 40 percent seat and depower the SRS.
Forward/Reverse motor
2. NOTE: If equipped with memory seat, disconnect the memory seat motor sensor electrical connector and remove sensor from the motor.
Remove the forward/reverse motor.
1
Disconnect the electrical connector.
2
Pull to release the power seat drive cables from the motor.
3
Remove the four screws (two shown).
4
Remove the power seat motor.
Rear height motor
3. NOTE: If equipped with memory seat, disconnect the memory seat motor sensor electrical connector and remove sensor from the motor.
Remove the rear height motor.
1
Disconnect the rear height motor electrical connector.
2
Remove the roll pin.
