Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
a.
Apply battery voltage to the DSM wiring harness connector at location 1 (Figure 4).
b.
Briefly apply battery ground to the DSM wiring harness connector at location 2 (Figure 4).
9.
Using the remote power supply again, position the seat track between mid travel and 2" (50 mm) from the rear stop using the following steps.
a.
Apply battery voltage to the DSM wiring harness connector at location 2 (Figure 4).
b.
Briefly apply battery ground to the DSM wiring harness connector at location 1 (Figure 4).
10.
Disconnect the remote power supply.
11.
Tighten the four (4) bolts under the seat track (Figure 5).
12.
Reconnect the DSM electrical connector.
13.
Disconnect the horizontal seat motor and seat position sensor electrical connectors.
14.
Separate the horizontal seat motor assembly from the seat track studs using the following steps:
a.
Cut the two (2) horizontal motor drive cable tie straps at the inboard and outboard seat tracks.
b.
Remove the two (2) nuts.
c.
Using a suitable tool, pry up on the side of the horizontal motor bracket near the mounting stud and separate the bracket from the stud.
d.
Separate the horizontal motor bracket from the stud on the other side.
15.
Lift up on the horizontal motor and bracket assembly, remove the drive cable from each seat track, and remove the horizontal motor and bracket
assembly. If installing a motor kit, proceed to Step 2 of "INSTALLATION". If installing a potentiometer kit, proceed to Step 16.
16.
Make note of the seat position sensor alignment to the motor for installation, then remove the horizontal motor inboard cable and seat position
sensor. To remove the seat position sensor from the motor, pull straight out to disengage the locking tab. Proceed to Step 1 of "INSTALLATION".
