Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Seat Track: Service and Repair
Seat Track - Power
SEAT TRACK - POWER
Removal
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental
restraint system (SRS) must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
Inboard and outboard seat tracks
1. Remove the 40 percent seat and depower the SRS.
2. Remove the spring.
Driver seat
3. CAUTION: Make sure to remove all metal chips from seat position sensor and surrounding areas after drilling out rivet.
Remove the seat position sensor.
1
Disconnect the seat position sensor electrical connector.
2
Drill out rivet.
3
Remove the seat position sensor.
Inboard seat track
