Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
(1)
If the horizontal seat motor bracket has bends (Figure 1) a motor kit will need to be installed. Proceed to Step 4.
(2)
If the horizontal seat motor bracket is straight (Figure 2) only a potentiometer kit will need to be installed. Proceed to Step 4.
4.
Depower the supplemental restraint system (SRS). For additional information, refer to Workshop Manual Section 501-20B (SRS Depowering and
Repowering).
5.
Remove the driver seat. For additional information, refer to Workshop Manual Section 501-10 (Front Seat - 40 Percent).
6.
Loosen the four (4) bolts under the seat track (Figure 3).
7.
Disconnect the driver seat module (DSM) 24-pin electrical connector.
CAUTION
DO NOT APPLY POWER TO THE DSM IN THE FOLLOWING STEPS, OR DAMAGE WILL OCCUR.
8.
Using a remote power supply, position the seat track off the rear stop to full forward position using the following steps:
