Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Parking Brake Cable: Service and Repair
Cable and Conduit - RH Rear
Removal and Installation
1. NOTE: The parking brake control is shown removed for clarity.
Make sure tension on the parking brake cables is fully released.
-
While a helper pulls down on the front cable, insert a pin through the park brake control frame and cam.
2. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
3. Disconnect the RH rear cable.
^
Remove the RH rear cable from the cable line.
^
Compress the cable clip and release the conduit from the equalizer.
4. Remove the RH rear cable from the retaining clip.
