Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
15. Remove the nuts and the remaining line brackets.
16. NOTE: If installing only one auxiliary heater line, cut only the desired line.
Assemble and lay out the replacement line(s) in the same position as the existing line(s) and, using a suitable tool, cut the auxiliary heater line(s) in
the same position as the fittings on the new line(s).
17. Remove the auxiliary heater line(s) in three separate pieces.
Installation
1. Partially lower the vehicle.
2. Attach the rear portion of the auxiliary heater lines.
1
Connect the heater hoses.
2
Install the line bracket.
3
Install the bolts.
3. Install the front auxiliary heater line(s) and connect the heater hose(s).
-
Clean and lubricate the heater hoses with plain water only if needed.
4. Raise the vehicle.
5. NOTE: Loosely connect, but do not tighten, the fittings.
Install the middle auxiliary heater line(s).
