Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
4. Reposition the seat cushion trim cover over the safety belt buckle and pretensioner and attach the hook-and-loop strip.
5. Attach the seat backrest J-clip to the seat cushion frame.
6. Install the 40 percent front seat on the side with the affected safety belt buckle and pretensioner.
7. Repower the SRS.
8. Check the active restraint system for correct operation.
Safety Belt Buckle and Pretensioner - 60 Percent Seat
SAFETY BELT BUCKLE AND PRETENSIONER - 60 PERCENT SEAT
Removal
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental
restraint system (SRS) must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Position the seat to gain access to all seat fasteners.
2. Depower the SRS.
3. Remove the 60 percent front seat.
