Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Ride Height Sensor: Service and Repair
Suspension Height Sensor
Removal and Installation
NOTE: Front shown, rear similar.
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the LH quarter trim panel. Failure to do so may
result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Disconnect the sensor arm.
3. Remove and discard the nuts (front height sensor).
4. Remove and discard the bolts (rear height sensor).