Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Starter Motor: Service and Repair
STARTER MOTOR
Removal and Installation
WARNING: When carrying out maintenance on the starting system be aware that the heavy gauge leads are connected directly to the battery.
Make sure the protective caps are in place when maintenance is completed. Failure to follow these instructions may result in personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the starter terminal cover and remove the nut and the solenoid S terminal electrical connection.
-
To install, tighten to 6 Nm (53 lb-in).
4. Remove the nut and the solenoid B terminal electrical connection.
-
To install, tighten to 12 Nm (9 lb-ft).
