Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
4. Using the special tool, remove the power steering pump pulley.
Installation
1. CAUTION: If the pulley has been removed and installed twice, install a new power steering pump pulley.
Using the special tool, install the power steering pump pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is 1 paint mark or none
at all, use a paint pencil to mark the web area of the pulley near the hub.
2. Install the air cleaner outlet canister and pipe.
^
Connect the electrical connector and tighten the air cleaner outlet canister and pipe clamps.
3. Connect the MAF sensor electrical connector.
4. Rotate the tensioner clockwise and install the engine accessory drive belt on the power steering pump pulley.
