Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
2. Remove the cooler tubes retainers.
3. Remove the section of the steel tube as illustrated.
^
Clean and de-burr the end of the steel tubes.
4. NOTE: Be sure the cooler tube is fully seated in the body of the fitting before final tightening of the ferrule nut.
Install the tubing ferrule hose assembly connector onto the end of the steel fluid cooler tubes. Finger-tighten the ferrule nut, then tighten the nut an
additional 1-1/2 turns to seat the ferrule in the connector.
5. CAUTION: The filter has a bypass valve in it. The red arrow on the filter indicates the direction of fluid flow through the filter. The filter must
be installed in the fluid cooler return line with the red arrow on the filter pointing away from the transmission fluid cooler and toward the
transmission (the return line has fluid coming out of the cooler going to the transmission). If the fluid filter is not installed correctly, it will cause
internal transmission damage.
